Reviewer:
Anthony from New Bern , NC United States
Over all it works. But it needs deeper detents and more of them to allow for better timing.In addition it needs to be cut so you can use a wrench to attached brakes etc on the business end. Just food for though.
Was this review helpful to you?
0 of 0 people found the following review helpful:
24x1 308 adapter
July 28, 2022
Reviewer:
Chadwick Harris from Independence, MO United States
Worked perfect no baffle strikes
Was this review helpful to you?
0 of 0 people found the following review helpful:
Issue resolved easily
February 18, 2022
Reviewer:
William Hawkins from Crofton, MD United States
The detent slot you need can easily be deepened with a simple file. Mounted my YHM Suppressor without issues after the correction was made. A simple procedure that only takes a few minutes, no big deal. Use teflon plumbing tread tape on your threads if there's any slight wobble.
Was this review helpful to you?
1 of 2 people found the following review helpful:
No
November 22, 2021
Reviewer:
Bro from TX United States
The other review about summed it up. Just here to second it. Spend money on something better. If you just want to mount a muzzle device get after it.
I would not trust to mount a can at all.
Was this review helpful to you?
4 of 6 people found the following review helpful:
Not good enough
January 29, 2018
Reviewer:
Matthew Kibbe from Round Rock, TX United States
These adapters need 2 things across all sizes: 1. wrench flats so that you can tighten your muzzle device to the adapter beyond hand tight 2. deeper and beefier detents for the AK's detent pins.
The adapters are notable weaker metal than the material used on ak detent pins - so the detents get marred, especially since on many of the adapters only half the detent pin goes into the slot and never deep enough.
Needs improvements 
24x1 308 adapter 
Issue resolved easily 
No 
Not good enough