9mm Barrel Guide Rod
Stock Status:(Out of Stock)
Email me when Back-In-Stock
Material: 4140, Pre-Hardened to 32 Rc
Length extending out from barrel: 9"
This guide rod can be used to check bore alignment on 9mm firearms. It is turned from heat treated material on a swiss-style CNC lathe in one long cut to maintain optimum straightness.
It sets down into the barrel ID and stops on the crown, allowing you to inspect alignment to suppressors or long muzzle devices.
*** We did not black oxide these rods because the natural steel color contrasts better with most muzzle devices. Therefore the rods should be kept oiled to prevent rust while in storage.
Mfg by CNC Warrior LLC
Made in USA
Share your knowledge of this product.
Be the first to write a review »
Terms & Conditions
All Rights Reserved.